P
S
I
P
S
I
NO MINIMUM
DISTANCE REQUIRED
A
PROJECTION
Tel: (206) 789-5410 Fax: (206) 789-5414
Drawn By:
Checked By:
Approved By:
Date:
Scale:
Job #Part #
Title:
Dwg. #Size:
Sht. No.: Rev.:
TOLERANCES
151 S. Michigan St., Seattle, Washington. USA 98108
SPECIFIED
B
UNLESS OTHERWISE
WITH ANSI/ASME Y14.5-2009
DRAWING
1
ASDI STD
1
N/A
0903-8001 of
ZIMMER 1PH SINGLE UNIT INSTALLATION DRAWING
1:8 AND NOTED
SCALE
1/15/2018
DN
INTERPRET THIS DRAWING IN ACCORDANCE
DO NOT
1/4"
ALL RIGHTS RESERVED.© COPYRIGHT ALGAS-SDI
.XXX
MANNER DETRIMENTAL TO ALGAS-SDI'S INTERESTS.
AND SHALL NOT BE REPRODUCED OR USED IN ANY
.XX
THIS DRAWING IS PROPRIETARY AND CONFIDENTIAL
0.030
0.10
0.010
.X
ANGLE 1
FRACTIONS
THIRD ANGLE
AAS
REVISIONS
REV. DESCRIPTION DATE NAME ECR/ECN
A INITIAL RELEASE 1/15/2018
AAS
NOTES:
FOLLOW ALL LOCAL CODES & REGULATION FOR INSTALLATION1.
LEAK TEST ALL CONNECTION AFTER INSTALLATION.2.
ADDITIONAL UNIONS MAY BE REQUIRED AND ARE RESPONSIBILITY 3.
OF THE CUSTOMER
OPTIONAL
BY-PASS
ISOLATION VALVE WITH
HYDROSTATIC RELIEF
LPG IN
LPG OUT
DRIP LEG W/SHUT
OFF VALVE AND PLUG
OUTLET REGULATOR
SET BELOW VAPORIZER
OUTLET REGULATOR
FILTAIRE GAS TRAP
OUTLET REGULATOR
WITH FLUORCARBON
ELASTOMERS
LPG VAPOR OUT
IF USING PE PIPING PLACE OUTLET
VALVE 2 METERS (6'-7') AFTER VAPORIZER
OUTLET. PE PIPING CAN BE USED FROM THIS
POINT ON.
FACTORY INSTALLED
EXPLOSION PROOFS
SEAL
3/4" CONDUIT
BOX
CABLE OR CONDUIT
SUITABLE FOR LOCATION
FILTAIRE GAS TRAP
To Next Page
