Align Trex SE - System Mode Configuration; Function Mode Operations; CCPM Mixing Parameters

Align Trex Se Setup Guide
System Mode.
❍ Press scroll until TYP is displayed.
❍ Press increase and select HE.
❍ Press scroll until GER is displayed.
❍ Press increase and select A
❍ To save either turn the radio off or press scroll and increase at the same time.
● Now we will set options in Function Mode.
❍ Turn the radio on if it is not already on.
❍ Press scroll and increase. You are now in function mode.
❍ The servo reversing menu (REV.NORM) should be visible. If not press scroll until it is.
❍ Once you reach the reversing menu, use the channel key to scroll through each channel and set
them to the following.
■ AIL=REV
■ ELE=NORM
■ RUD=NORM
■ GER=NORM
■ PIT=NORM
■ THR=NORM
❍ Press scroll until TRV ADJ. is visible.
❍ Press scroll and select the GER channel.
❍ Place the Aileron DR switch to 0. Use the decrease button to set +45%.
❍ Press scroll until HLD is visible.
❍ Use decrease and set to -1%.
❍ Press scroll until you reach the Pitch Curve Menu. Use the channel button to select PLN, P2N and
PHN and set the following values using increase and decrease.
■ PLN=35%
■ P2N=50%
■ PHN=100%
❍ Press scroll to advance to the next Pitch Curve Menu. Use the channel button select PLS, P2S and
PHS and set the following values using increase and decrease.
■ PLS=0%
■ P2S=50%
■ PHS=100%
❍ Press scroll to advance to the next Pitch Curve Menu. Use the channel button select PLH, P2H and
PHH and set the following values using increase and decrease.
■ PLH=0%
■ P2H=50%
■ PHH=100%
❍ Press scroll to advance to the Throttle Curve Menu. Use the channel button select TLN, T2N and
THN and set the following values using increase and decrease.
■ TLN=0%
■ T2N=65%
■ THN=100%
❍ Press scroll to advance to the Throttel Curve Menu. Use the channel button select TLS, T2S and
THS and set the following values using increase and decrease.
■ TLS=100%
■ T2S=80%
■ THS=100%
❍ Press scroll until your reach the CCPM Menu. "mix CCP OF" is displayed.
❍ Press increase to enable CCPM. Display will change from CCP OF to CP2.
❍ Use the channel button to select CP2, CP3 and CP6. All three should have a value of 60% by
default. Use increase and decrease to set the following values.
■ CP2 = 30% (Approximately 6 degrees of total cyclic travel [ -, + 3 degrees left and right] )
■ CP3 = 30% (Approximately 6 degrees of total cyclic travel [ -, + 3 degrees forward and aft] )
■ CP6 = 60%
■ CP2 and CP3 adjusts the cyclic travel of your swashplate (forward, back, left, right)
■ CP6 adjust the total up and down travel of the swashplate (pitch of rotor blades)
http://www.digimemphoto.com/pdf/ (2 of 13)1/25/2006 7:09:05 PM