Need help?Do you have a question about the Align TREX 700 and is the answer not in the manual?
General| Brand | Align |
|---|---|
| Model | TREX 700 |
| Skill Level | Advanced |
| Type | Helicopter |
| Power Source | Electric |
| Main Blade Length | 690mm |
| Tail Blade Length | 105mm |
| Weight (w/o power system) | 3200g |
| Battery | LiPo |
| Radio | Not included |
| Charger | Not included |
Provides warnings on frequency interference, operating ability, and model care.
Shows receiver plugs and dual power bus/BEC connections.
Details modes like DIR, E.LIM, E.REV, A.LIM, A.REV for setup.
Covers rudder gyro setup modes like frame rate and servo type.
Essential checks before starting the setup process.
Emphasizes digital servos and power circuit details.
Steps for first-time setup and when to repeat it.
Steps to enter DIR settings by holding the SET button.
Turns on transmitter/receiver and system initialization.
Checks aileron compensation by tilting the helicopter to the right.
Verifies swashplate movement and checks for errors.
Checks swashplate binding and adjusts Center of Gravity.
Checks elevator compensation by tilting the helicopter forward.
Restarts system and begins flight test after checks.
Recommends soft surfaces and skid stoppers for testing.
Observes oscillations and adjusts ELE/AIL gain dials.
Addresses blade tracking and low/high headspeed problems.
Fixes tail issues like drifting, hunting, and oscillations.
Solves helicopter drift and slow/sensitive input response.
To Next Page
