Align TREX 700 Installation Instructions

www.KDEDirect.com
TREX 700 NITRO ELECTRONIC CONVERSION KIT
INSTALLATION INSTRUCTIONS
TOOLS REQUIRED:
4.5 mm Drill Bit (or equivalent ANSI #16 drill bit)
Manual or Power Drill
Motor Mount Installation Adhesive Diagrams (supplied with kit)
Drill the four orange-highlighted holes to 4.5 mm
diameter using the required drill bit and a manual
and/or power drill.
Attach the Motor Mount Installation Adhesive Diagram
to the frame (left and right sides provided for
corresponding frame pieces).
Drill the three Motor Mount hole locations (previous M3
mount editions have two locations) to 4.5 mm diameter
as directed by the orange crosshairs shown on the
Adhesive Diagram.
REVISION 4

Align TREX 700 Specifications

General

Brand	Align
Model	TREX 700
Skill Level	Advanced
Type	Helicopter
Power Source	Electric
Main Blade Length	690mm
Tail Blade Length	105mm
Weight (w/o power system)	3200g
Battery	LiPo
Radio	Not included
Charger	Not included