Align TREX 700 - Safety Notes and Warnings; General Notices and Precautions

www.KDEDirect.com
TREX 700 NITRO ELECTRONIC CONVERSION KIT
INSTALLATION INSTRUCTIONS
Install the M3 x 0.5 x 8 mm Socket Button Head Collar Screws to the blue-highlighted
locations (installation repeated on opposite side of frame).
Install the M3 Flat Washer, M3 x 0.5 Locknut, and the original Canopy Mounting Bolt to the
red-highlighted locations.
PARTS REQUIRED:
M3 x 0.5 x 8 mm Socket Button Head Collar Screws (included in original T700N kit)
M3 Flat Washers (supplied with kit)
M3 x 0.5 Locknuts (supplied with kit)