Need help?Do you have a question about the Align TREX 700E and is the answer not in the manual?
Details a comprehensive checklist to ensure the helicopter is safe and ready for flight.
Step-by-step instructions for assembling the main rotor head components.
Details the procedure for setting the tail rotor neutral point and gyro settings.
Provides throttle and pitch settings for general flight mode.
Details throttle and pitch settings optimized for 3D flight mode.
Provides an overview of the initial setup steps for the flybarless system.
Details the procedure for setting up the rudder gyro.
Explains servo selection and how to check/adjust rudder direction.
Instructions for setting the rudder servo endpoint limits.
Guides through the initial system startup and pre-flight checks.
Explains how to check for oscillations and adjust gyro gain.
Details checks for helicopter tilting and control responses during setup.
Details adjustments needed for stable forward flight.
Details how to adjust hover stability and trim the helicopter's controls.
Lists common problems encountered during operation and their solutions.
To Next Page
General