6
Switch between talk around and repeater mode
Turn on/off the frequency reverse function
Choose the encryption group to encrypt the call conversation
In Analog mode, send the DTMF/5TONE/2TONE encode.
This function is only valid for analog channel
Switch between VFO mode and memory channel mode.
Sub channel PTT, press to start the call on sub channel
When select alarm, long press the key to start alarm, short
press again to exit the alarm.
Enable/disable the recording function when TX or RX a call
conversation
Start/stop recording as a recorder. When stop recording, the
radio will remind repeat or send the record
In digital mode, press to enter into message box, only private
call and group call can send and receive a message
Check the GPS position information
Monitor the weak signal in analog mode or the signal with
unmatched ID or color code in digital mode
Choose channel A or channel B as the main channel
Press the key to perform the programmed function in hot key
setup
Turn on/off the work alone function
During scanning, press the key to skip the unwanted channel
In DMR mode, press the key to turn on/off monitor a target
radio