Alinco DJ-MD5X - Default Function; Hot Key

8
Roaming
In standby, press the key programmed as "Roaming" to search and
lock on the repeater with strongest signal. (Note: After lock on a
repeater, the radio will return to last frequency only after channel
or frequency is changed. The repeater frequency list must pre-
programmed in CPS.)
Channel raging
In standby, if the call contact type for a channel is "Single call" ,
press the key programmed as " Channel Ranging" to turn on this
function. The radio will automatically start ranging function when
turn to this channel.
Max volume
In standby, press the key programmed as" Max Volume", will
enable
users to set the maximum RX volume.
Slot switch
Choose Slot for current channel, this function is only valid in
repeater mode.
APRS type switch
Choose Aprs Type for current channel.
Zone select
In standby, press the programmed "Zone Select" key, it will allow
you input the zone number and then press confirm key will switch
to the zone.
timed roaming set
Sets Roaming Function
APRS set
Sets APRS Function
Mute timming
Set the radio mute in a pre-setting time
CTC/DCS set
Set CTCSS/DCS funtion
O
3. Default function
The table below shows the functions as default functions were assigned to
programmable keys.
Key
Default Function
[PF1] Short Press
Main channel Switch
[PF1] Long Press
V/M
[PF2] Short Press
Monitor
4. Hot Key
In PC software  Public  Hot key, it is able to set different functions for hot key
~ and the combine (MENU)+ number key. For details please refer to the
PC software.