ALLEN & HEATH MixWizard Series - Tools Required

ALLEN & HEATH
MIXWIZARD WZ14:4:2 SYS-LINK OPTION2
FITTING THE SYS-LINK EXPANDER OPTION
D type connector
fixings already fitted.
4 x AB2189
Œ
FLAT BLADE
SOLDER
1pt CROSS POINT
•
TOOLS REQUIRED :
LONG NOSE
SOLDERING IRON
with small tip
Contents:
1x SYS-LINK circuit board assembly with interconnecting harness and D type connector fixings already
fitted.
1x SYS-LINK Fitting Instructions (AP3220)
1x SYS-LINK Application notes (AP3221)
fig. 1
CHECK THE CONTENTS :
Please carefully check the SYS-LINK circuit board assembly is the correct one for the console in which
it is to be installed.
INPUT
OUTPUT
Ribbon A Ribbon B
Harness C
12mm NUTDRIVER
CUTTERS