ALLEN & HEATH
MIXWIZARD WZ14:4:2 SYS-LINK OPTION6
’
Bend the cut vertical TC buss wires back down and resolder them.
Lift the SYS-LINK circuit board assembly and locate the TC buss wires into the slots on the circuit board.
Make sure the SYS-LINK circuit board assembly is located centrally between the Stereo input circuit board
and the Group circuit board assemblies.
Check the TC buss wires are located in the correct slots and carefully solder each one.
Solder red and black wires as shown in fig. 6.
SOLDERING THE SYS-LINK CIRCUIT BOARD ASSEMBLY:
Solder wires
onto TC buss
ñ
Slots
BUSS WIRES
fig. 6
SYS-LINK
circuit board
Buss wires
Harness C
To Next Page
Loading...
