Need help?Do you have a question about the ALLEN & HEATH ZED-10FX and is the answer not in the manual?
General| Mic Inputs | 4 |
|---|---|
| Line Inputs | 6 |
| USB Audio Interface | Yes |
| Built-in FX | Yes |
| Aux Sends | 2 |
| Channels | 10 |
| EQ Bands | 3-band |
| Phantom Power | Yes |
| Main Outputs | XLR |
| Other Outputs | RCA |
| Headphone Output | 1/4" |
Details the product warranty terms and conditions.
States compliance with European directives and Allen & Heath's testing policy.
Instructions on reading warnings, cover, power, cord routing, and grounding.
Advice on water, moisture, ventilation, heat, servicing, and installation.
Details on wire colours for mains plug replacement (European/USA).
Precautions for preventing damage, cleaning, transport, and hearing protection.
Lists the items that should be included in the product package.
Details design, multi-application use, mic/line pre-amps, and Hi Z inputs.
Describes EQ, built-in effects processor, record bus, and USB connectivity.
Notes the unit features a built-in power supply, not an external adapter.
Details operating levels and frequency response characteristics.
Provides THD+n, headroom, and noise level specifications.
Details USB audio interface compliance and sample rates.
Shows physical dimensions (width, height) and weight of the mixer.
Illustrates the internal signal flow and component connections of the mixer.
Describes Mic/Line input sockets and the gain adjustment for signal levels.
Describes the filter for reducing pop noise and rumble from microphone signals.
Explains the High, Mid, and Low Frequency equalizer controls and their functions.
Details FX Send, AUX Send, PAN, LEVEL, Record, and Listen controls.
Details the high impedance FET inputs for instruments and the gain boost switch.
Describes ST-1b (RCA) and ST-1a (1/4") inputs and the gain adjustment.
Explains the high and low frequency equalizer for stereo channels.
Details FX Send, AUX Send, Balance, LEVEL, Record, and Listen controls.
Describes USB input, Record OUT, Playback Input, and source selectors.
Explains Effects Type LEDs, Bank LED, SEL/TAP buttons, FX sends, and levels.
Lists and describes all 16 preset effects with parameter adjustments.
Details Main Mix Out, Insert sockets, FX/Aux outputs, 48v, Monitor, Aux, and Main Mix levels.
Describes stereo meters, PFL LED, headphone level, source selection, and output.
Explains the USB audio interface, driver compatibility, and software use.
Advises checking computer audio device levels if transfer is low.
Illustrates a typical live mixing setup with various instruments and speakers.
Depicts a typical studio recording setup with computer and other gear.
Shows insert cable wiring and general diagrams for various audio cables.
Instructions on registering the product online or by mail for warranty.
To Next Page