Publication 1763-RM001C-EN-P - October 2009
Knowledgebase Quick Starts 547
1. Select “I/O Configuration”
2. Highlight the “MicroLogix 1100“
3. Select “Adv Config“
4. Select the “Embedded I/O Configuration” Tab
5. Adjust Input filters as needed
Problem #2: The HSC instruction does not accumulate counts and the
Error Code (ER) shows a value of (1).
Solution:A file number was entered into (PFN) but the value entered was
less then (3) or greater then (255) or the file number entered was correct,
however the file does not exist.
Create the NEW program file by “Right” mouse clicking on “Program
Files”
efesotomasyon.com - Allen Bradley,Rockwell,plc,servo,drive
To Next Page
Loading...
