292 Rockwell Automation Publication 1769-UM021G-EN-P - October 2015
Chapter 11 Develop Integrated Motion over an EtherNet/IP Network Application
6. If you must change the configuration for any of the following parameters,
click Change in the Module Definition area:
• Revision
• Electronic Keying
• Connection
• Power Structure
• Verif y Power Rating on Conne ction
The Module dialog box appears.
7. Make the desired changes and click OK.
8. Click OK to create the drive in your project.
9. Add other components that your project requires.
To Next Page
Loading...
Need help?
General
