Allen-Bradley 5069-L306ER User Manual

Installation Instructions
Original Instructions
CompactLogix 5380 Controllers
Catalog Numbers 5069-L306ER, 5069-L306ERM, 5069-L310ER, 5069-L310ER-NSE, 5069-L310ERM, 5069-L320ER, 5069-L320ERM, 5069-L330ER,
5069-L330ERM, 5069-L340ER, 5069-L340ERM, 5069-L350ERM, 5069-L380ERM, 5069-L3100ERM
The CompactLogix™ 5380 controllers can operate in various applications, including the use of local Compact 5000™ I/O modules and remote I/O
modules and Integrated Motion over an EtherNet/IP network. The controllers offer the following:
• High-speed backplane packet transfer rate
• Embedded dual 1 Gb Ethernet ports
• Multiple programming languages that enable sequential, process, motion, and drive control
You use the Studio 5000 Logix Designer® application to configure CompactLogix 5380 controllers.
For more information on the components that are required to install a CompactLogix 5380 controller, see
page 5. For more information on how to
use the controller after you install it, see the publications that are listed in
Additional Resources on page 15.
Summary of Changes
The publication has been changed as follows:
• Add Waste Electrical and Electronic Equipment (WEEE) information on
page 3.
• Add information about how to install an end cap on
page 11.
Topic Page
About the Controller 5
Required System Components 5
Install the Controller onto the DIN Rail 8
Connect External Power Supplies to the Controller 8
Install Compact 5000 I/O Modules 11
Install the End Cap 11
Power the System 12
Set the Network Internet Protocol (IP) Addresses 12
Connect the Controller to an EtherNet/IP Network 12
Remove or Replace the Controller 13
Specifications 14
Additional Resources 15

Allen-Bradley 5069-L306ER Specifications

General

Model	5069-L306ER
Processor Speed	1 GHz
Ethernet Port Speed	1 Gbps
Power Supply Voltage	24V DC
Communication Ports	1 Ethernet port, 1 USB port
I/O Modules Supported	Compact 5000 I/O modules
Operating Temperature	0 to 60 °C
Certifications	CE, UL

Summary

Installation Instructions

Hazardous Location and ESD Precautions

Special Conditions for Safe Use

Lists critical safety requirements for using the equipment in specific hazardous environments.

Prevent Electrostatic Discharge (ESD)

Controller Overview

Required System Components

System Planning

Dimensions and Power Considerations

System Power Considerations

Explains power supply requirements and considerations for MOD and SA power.

Ground Considerations

Install Controller and MOD Power RTB

Install the Controller onto the DIN Rail

Step-by-step instructions for mounting the controller on a DIN rail.

Install the MOD Power RTB

Instructions for installing the removable terminal block for MOD power.

Connect External Power Supplies

Connect MOD Power

Detailed steps for connecting the external MOD power source to the RTB.

Install SA Power RTB and Connect SA DC Power

Install the SA Power RTB

Instructions for installing the removable terminal block for SA power.

Connect SA DC Power

Steps for connecting the external SA DC power source.

Connect SA AC Power

Connect SA AC Power

Detailed steps for connecting the external SA AC power source.

Install I/O Modules and End Cap

Install Compact 5000 I/O Modules

Install the End Cap

System Power-Up and Network Configuration

Power the System

Set IP Addresses

Connect to EtherNet/IP Network

Remove or Replace Controller

Remove or Replace the Controller