Allen-Bradley 5069-L306ERM User Manual

Installation Instructions
Original Instructions
CompactLogix 5380 Controllers
Catalog Numbers 5069-L306ER, 5069-L306ERM, 5069-L310ER, 5069-L310ER-NSE, 5069-L310ERM, 5069-L320ER, 5069-L320ERM, 5069-L330ER,
5069-L330ERM, 5069-L340ER, 5069-L340ERM, 5069-L350ERM, 5069-L380ERM, 5069-L3100ERM
The CompactLogix™ 5380 controllers can operate in various applications, including the use of local Compact 5000™ I/O modules and remote I/O
modules and Integrated Motion over an EtherNet/IP network. The controllers offer the following:
• High-speed backplane packet transfer rate
• Embedded dual 1 Gb Ethernet ports
• Multiple programming languages that enable sequential, process, motion, and drive control
You use the Studio 5000 Logix Designer® application to configure CompactLogix 5380 controllers.
For more information on the components that are required to install a CompactLogix 5380 controller, see
page 5. For more information on how to
use the controller after you install it, see the publications that are listed in
Additional Resources on page 15.
Summary of Changes
The publication has been changed as follows:
• Add Waste Electrical and Electronic Equipment (WEEE) information on
page 3.
• Add information about how to install an end cap on
page 11.
Topic Page
About the Controller 5
Required System Components 5
Install the Controller onto the DIN Rail 8
Connect External Power Supplies to the Controller 8
Install Compact 5000 I/O Modules 11
Install the End Cap 11
Power the System 12
Set the Network Internet Protocol (IP) Addresses 12
Connect the Controller to an EtherNet/IP Network 12
Remove or Replace the Controller 13
Specifications 14
Additional Resources 15

Allen-Bradley 5069-L306ERM Specifications

General

Power Supply	24V DC
Product Type	Controller
Communication Ports	USB
Ethernet Ports	2
Operating Temperature	0 to 60 °C
Certifications	CE, UL, cUL
Controller Series	CompactLogix 5069
I/O Modules Supported	5069 Compact I/O

Summary

Installation Instructions

Hazardous Location and ESD Precautions

IEC Hazardous Location Approval

Prevent Electrostatic Discharge (ESD)

Controller Overview and Components

Required System Components

Lists essential components needed for controller installation.

Physical Specifications and Power

System Power Considerations

Details power supply requirements and considerations for the system.

Ground Considerations

Outlines essential grounding procedures for system safety and reliability.

Core Installation Procedures

Install Controller onto DIN Rail

Step-by-step guide to mounting the controller on a DIN rail.

Install Removable Terminal Blocks (RTBs)

Instructions for installing MOD and SA power RTBs onto the controller.

Connect Power Supplies

Guides for connecting external power supplies to the controller's RTBs.

Power Connection Details

Connect SA DC Power

Details connecting the DC power supply to the SA power RTB.

Install SA Power RTB

AC Power Connection

Connect SA AC Power

Module and End Cap Installation

Install Compact 5000 I/O Modules

Install the End Cap

System Power-Up and Network Configuration

Power the System

Steps to turn on power to the controller and system.

Set Network IP Addresses

How to assign IP addresses to the controller's Ethernet ports.

Connect to EtherNet/IP Network

Controller Removal and Replacement

Remove or Replace the Controller