Allen-Bradley 5069-L310ER User Manual

Installation Instructions
Original Instructions
CompactLogix 5380 Controllers
Catalog Numbers 5069-L306ER, 5069-L306ERM, 5069-L310ER, 5069-L310ER-NSE, 5069-L310ERM, 5069-L320ER, 5069-L320ERM, 5069-L330ER,
5069-L330ERM, 5069-L340ER, 5069-L340ERM, 5069-L350ERM, 5069-L380ERM, 5069-L3100ERM
The CompactLogix™ 5380 controllers can operate in various applications, including the use of local Compact 5000™ I/O modules and remote I/O
modules and Integrated Motion over an EtherNet/IP network. The controllers offer the following:
• High-speed backplane packet transfer rate
• Embedded dual 1 Gb Ethernet ports
• Multiple programming languages that enable sequential, process, motion, and drive control
You use the Studio 5000 Logix Designer® application to configure CompactLogix 5380 controllers.
For more information on the components that are required to install a CompactLogix 5380 controller, see
page 5. For more information on how to
use the controller after you install it, see the publications that are listed in
Additional Resources on page 15.
Summary of Changes
The publication has been changed as follows:
• Add Waste Electrical and Electronic Equipment (WEEE) information on
page 3.
• Add information about how to install an end cap on
page 11.
Topic Page
About the Controller 5
Required System Components 5
Install the Controller onto the DIN Rail 8
Connect External Power Supplies to the Controller 8
Install Compact 5000 I/O Modules 11
Install the End Cap 11
Power the System 12
Set the Network Internet Protocol (IP) Addresses 12
Connect the Controller to an EtherNet/IP Network 12
Remove or Replace the Controller 13
Specifications 14
Additional Resources 15

Allen-Bradley 5069-L310ER Specifications

General

Catalog Number	5069-L310ER
Communication Ports	Ethernet/IP, USB
Power Supply Voltage	24V DC
Product Type	CompactLogix Controller
Memory	1 MB
Operating Temperature	0°C to 60°C
I/O Capacity	Up to 32 modules

Summary

Hazardous Location Approvals

Safety and Hazardous Location Information

Controller Overview

Required System Components

Lists the essential components needed for the installation of the controller.

System Planning and Installation

Components Needed to Install a CompactLogix 5380 Controller

Details the necessary tools, DIN rail, software, and network components for installation.

System Specifications and Power

System Power Considerations

Explains power requirements, voltage ranges, and current ratings for the system.

Ground Considerations

Details the grounding requirements for the DIN rail and controller for safety.

Installation Procedures

Install the Controller onto the DIN Rail

Step-by-step instructions for mounting the controller onto a DIN rail.

Install the MOD Power RTB

Guide for installing the Removable Terminal Block for MOD power.

Connect External Power Supplies to the Controller

Instructions for connecting external power sources to the controller's RTBs.

Connect MOD Power

Detailed steps for connecting the MOD power supply to the controller.

Power Connection Details

Connect SA DC Power

Install the SA Power RTB

AC Power Connection

Connect SA AC Power

Module Installation and Disconnection

Install the End Cap

System Operation and Networking

Power the System

Set the Network Internet Protocol (IP) Addresses

Connect the Controller to an EtherNet/IP Network

Controller Maintenance

Remove or Replace the Controller

Specifications