Installation Instructions
Original Instructions
FLEX 5000 EtherNet/IP Adapters with RJ45 Ports
Catalog Numbers
5094-AENTR, 5094-AENTRXT, 5094-AEN2TR, 5094-AEN2TRXT
Product Overview
The FLEX 5000™ EtherNet/IP Adapters with RJ45 Ports perform the following functions:
• Facilitate high-speed data transfer across an EtherNet/IP network between FLEX 5000 I/O modules and a Logix 5000™ controller.
• Provide system-side power to FLEX 5000 I/O modules.
• The 5094-AENTR and 5094-AENTRXT adapters support as many as 8 FLEX 5000 I/O modules.
• The 5094-AEN2TR and 5094-AEN2TRXT adapters support as many as 16 FLEX 5000 I/O modules.
The adapters are configured with the Studio 5000 Logix Designer® application. For more information on how to use FLEX 5000 EtherNet/IP
Adapters with RJ45 Ports, including the compatible Logix 5000 controllers and Logix Designer application versions, see the publications that are
listed in Additional Resources
on page 15.
Topic Page
About the Adapter 5
Before You Begin 5
Adapter Dimensions 6
Set the Network Internet Protocol (IP) Address 7
Install the Adapter onto the DIN Rail 8
Connect Power to the Adapter 9
Connect the Adapter to an EtherNet/IP Network 11
Install the End Cap 12
Power the Adapter 13
Remove or Replace the Adapter 13
Specifications 14
Additional Resources 15
To Next Page
Need help?
General
