Allen-Bradley PowerFlex 700H - Page 11

Rockwell Automation Publication PFLEX-IN015A-EN-P - March 2005 11
PowerFlex 700S and 700H Fan Inverter Upgrade Kit (Frame 9)
Step 5: Removing the Cross
Plate
Task Description
Disconnect the MOV if present.
Disconnect the Cross Plate fan if present.
Disconnect the grounding wires.
Proper tightening torque for reassembly is 4 N•m (35 lb•in).
Remove the three M4x8 Pozidrive screws, which secure the Cross Plate to the drive.
Proper tightening torque for reassembly is 3 N•m (27 lb•in).
Remove the Cross Plate from the drive.
A
B
C
D
E
Note the sequence of
hardware.