Publication 2711-UM014B-EN-P
C-2 European Union Directive Compliance
Intended Use of Product
According to these Standards, the factor which determines, for EMC
purposes, whether a product is deemed to be "Industrial" rather than
"Residential, commercial or light industrial", is given in clause 1 of
EN50081-2 as follows:
Apparatus covered by this standard is not intended for
connection to a public mains network supplied from a high- or
medium-voltage transformer dedicated for the supply of an
installation feeding a manufacturing or similar plant.
When installed in Europe, any other application is in contravention of
European Union Directives, and a breach of these laws.
The PanelView 900 color, the 1000 grayscale and the 1400 terminals
are certified for direct connection to a low-voltage public mains
supply or to a dedicated source, which is intended to interface to a
low-voltage public mains supply.
Wiring Recommendations
To reduce electrical noise, connect the PanelView terminal to its own
branch circuit. The input power source should be protected by a fuse
or circuit breaker rated no more than 15 amps. Route incoming power
to the PanelView terminal by a separate path from the
communications cable.
Where power and communication lines must cross, they should cross
at right angles. Communication lines can be installed in the same
conduit as low level DC I/O lines (less than 10 Volts).
Declarations of Conformity
Declarations of Conformity are available for each of the PanelView
terminals at the website www.ab.com/support under Product
Certification.
To Next Page
Loading...
Need help?
General
