allen MP235 - Spray System; Technical Specifications

x
053383; 11/10
Technical Specifications
Measurements in this manual are in U.S. units and their customary metric units (i.e., metric units
contained within brackets [8 mm]). The machine RIGHT-HAND and LEFT-HAND sides are deter-
mined by sitting on machine (SOM) facing in the direction the machine will travel when going
forward.
Machine Features:
• Dimensions (L x W x H) inch [mm] ..................86x38x53
(guard rings/top of seat) ...........................[2184x965x1346]
• Operating Weight lb [kg]
Honda ......................................
• Panning Path Width inch [mm] .....................85 [2159]
• Two Rotors (Diameter) inch [mm] ...................36 [914]
• Rotor Speed (RPM) ..............................110 - 135
• Finish Blade (8) inch [mm] .........................6 x 14 [152.4x355.6]
• Gearbox (2) ....................................Standard Duty (STD)
• Rotating Guard Rings ............................Standard
• Fixed Seat Frame ...............................Standard
• Powered Retardant Spray System ..................Standard
• Spray System Capacity gal [L]. . . . . . . . . . . . . . . . . . . . . .6 [23]
• Steering System .................................Dual Levers
• Gearbox Rotation ................................Standard
• Battery ........................................12 Volt
• Safety Shutdown Switch ..........................Seat Controlled
• Fuel Capacity gal [L] .............................6 [23]
• Run Time (Approximate) hr ........................2.5