3-10
SECTION 3
SERVICE
053383; 11/10
3.5
Right Hand Control Lever Adjust
3.5 RH Control Lever Adjustment Right Or Left Procedure
The right hand lever should be set to the same angle as that of the left to form a "V".
If levers become out of adjustment adjust the right hand lever as follows:
1) Remove jam nuts [D].
2) Remove bolt [C].
3) Extend linkage to move control levers to the right .
4) Shorten linkage to move control levers to the left.
5) After control lever has been adjusted to the desired position reassemble bolt
[C] and tighten jam nuts [D].
To Next Page
Loading...
