To Next PageTo Next Page
Need help?Do you have a question about the Alliance Laundry Systems 25 Pound Capacity and is the answer not in the manual?
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | 25 Pound Capacity |
| Category | Dryer |
| Language | English |
Lists applicable models for the manual.
Provides contact details for service and support.
Explains the meaning of DANGER, WARNING, CAUTION, IMPORTANT, and NOTE.
Provides essential safety precautions for operating the tumble dryer.
Covers general specs for 025, 030, 035, 055 series from the main table.
Provides dimensional data for 025, 030, 035, 055 and T30, T45 series.
Details exhaust outlet and gas connection locations for various series.
Shows electrical and steam connection locations for various series.
Covers inspection, location, and codes/permits.
Instructions on positioning, leveling, and using the fifth leveling leg.
Specifies water requirements, connections, and fire suppression system details.
Step-by-step guide to reverse the tumble dryer's loading door.
Final checks and procedures before operating the tumble dryer.
Covers requirements, general info, and orifices for CE gas dryers.
Specifies required airflow openings for different dryer models.
Provides recommendations for exhaust ducting and installation.
Guidance on individual exhaust venting and using a common collector duct.
Covers gas line connection, pressure, and safety warnings.
Guidance on sizing and looping gas supply pipes for proper pressure.
Instructions for reducing burner orifice size at high altitudes.
Covers safety warnings, grounding, and service connection points.
Procedures for connecting electrical service and converting voltages.
Provides detailed electrical specifications for various models.
Specifies pressure, piping diagrams, and safety notes.
Details steam line recommendations and steam trap/condensate connections.
Describes operational modes and dipswitch settings for configuring the timer.
Covers programming, test cycles, and troubleshooting error codes.
Covers general warnings, emergency stop, and basic operation.
Instructions for loading laundry and setting controls.
Describes operation for various controls like UniLinc, DX4, DMP, OPL.
Lists symptoms, probable causes, and corrective actions.
Explains ignition control operation for CE and Non-CE models.
Covers system tests and diagnostic LED error codes.
Instructions on adjusting the air shutter for proper flame and combustion.
Covers adjustment of airflow and loading door switches.
Instructions for adjusting the door strike for proper door tension.
Outlines daily cleaning and inspection procedures for the dryer.
Covers bi-annual, annual, and fire suppression system maintenance.
