Alliance Laundry Systems HCD020GD2 - Quarterly

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
F8208401ENR5
16
7. Use compressed air to clean lint from motor.
8. Clean interior of machine, both basket and shell,
by wiping with a water-soaked sponge or cloth.
9. Use compressed air to clean all electrical
components of moisture and dust.
10. Verify the insulation is intact on all external wires
and that all connections are secure. If bare wire is
evident, call a service technician.
11. For F and variable-speed models only, clean
AC drive cooling fan blades monthly (more often
if required by the condition of the air).
Quarterly
NOTE: Disconnect power to the machine at its
source before performing the quarterly
maintenance procedures.
1. Tighten door hinges and fasteners, if necessary.
2. Tighten anchor bolts, if necessary.
3. Verify that the drain motor shield is in place and
secure, if so equipped.
4. Check all painted surfaces for exposed metal.
(Matching paint is available from the
manufacturer.)
• If bare metal is showing, paint with primer or
solvent-based paint.
• If rust appears, remove it with sandpaper or by
chemical means and then paint with primer or
solvent-based paint.
5. Clean customer-supplied steam filter, where
applicable. Refer to Figure 9.
a. Turn off steam supply and allow time for the
valve to cool.
b. Unscrew cap.
c. Remove element and clean.
d. Replace element and cap.
Figure 9
6. Check the bearing mounting bolts to make sure
they are torqued properly. Refer to Table 3 for
specifications.
H042I
1 Cap
2 Filter Element
Machine
Capacity
Bearing Torque
20 All 75 ft-lbs.
30-60 All 105 ft-lbs.
80-125 Front 200 ft-lbs.
80-125 Rear 97 ft-lbs.
Table 3
H042I
1
2