806221 75
Adjustments
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
re
connected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
40. Shipping Braces
All stacked washer/dryers, when shipped from
the factory are equipped with two factory
installed shipping supports. DO NOT remove this
shipping material until after machine is placed in
its final installed position. Refer to Figure 8.
IMPORTANT: DO NOT tip or move washer once
these supports have been removed. Removal of
supports prior to final installation may cause
damage to the shock absorbers and will VOID the
product warranty.
NOTE: Shipping supports MUST be kept for
future re-positioning or moving of the machine.
Figure 8
Shock
Absorber
Shipping
Support
Shock
Absorber
Shipping
Support
Shipping
Bracket
To Next Page
Loading...