Installation on a steel base and floor
1. Nuts M16; supplied with the machine
2. Washers; 60mm external diameter, 16.5mm internal diameter, 6mm thickness; supplied with the machine
3. Spacing washer
4. Anchor bolt
5. Washing machine
6. Concrete floor
7. Bolt (supplied with steel base)
Figure 9
NOTE: The existing concrete floor must be at least 4.72
in. [120 mm
] thick.
NOTE: North American Models: Mounting bolt holes
should be made to a depth of 3.5 in.
1. Check that the machine is installed in a level and stable man-
ner in all its corners.
2. Models outside of North America: If necessary, level the ma-
chine up by means of stainless or galvanized spacing washers
inserted between the machine frame and the floor. Refer to
Figure 10 and Figure 11 . The dimensions of the spacers must
be the same as the dimension of the machine frame in the
place where the anchor bolts are located (80 x 80 mm).
3. Fit a washer and self-locking nut on the anchor bolt and tight-
en with a torque wrench to 100Nm.
NOTE: It is advisable to recheck the torque after a
short period of machine operation.
4. Using the bottom frame of the machine, lift the whole ma-
chine and place over the four drilled holes.
5. Check that the machine is seated in a perfectly level manner.
6. North American Models: grout under the machine to ensure a
stable installation. Refer to Machine Grouting (North Ameri-
can Models Only).
7. Using mechanical or chemical anchor bolts, mount the ma-
chine to the floor or steel base.
NOTE: Mounting bolts are not included with the ma-
chine.
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
34 Part No. D1599ENR16
To Next Page
Loading...
