12 806221
General Troubleshooting
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must
be
re
connected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
EXIT column key:
1-exit by Start/Pause keypress
2-exit by fill level satisfaction
3-exit when all keypads are pressed
4-exit when door is unlocked
5-exit when temp reaches 40
°C
6-exit when step timed out
7-exit when door locks
8-exit when overflow level reached
9-exit when drum is empty
10-exit when door is closed
11-exit when door is opened
12-exit when drive communication is established
13-exit when machine unpowered
Table 3 (continued)
# Display
Status
LEDs Lit
Motor Valves Door Pump Dump Exit* Step
18
Pu for pump
installed
dr for gravity
drain installed
Rinse Off None Locked On Open 9
Pump/Gravity
Drain
19 actual RPM Spin
Fac-
tory
Spin
Profile
None Locked On Open 1 Factory Spin
20 bA Spin
Break-
away
Agitate
Hot, Cold,
Detergent,
Softener,
ES
1, 2, 3, 4,
Cycle
Output
Unlocked On Open
1, 1
Again
Then
4
Then
11
Breakaway
21 Pd Spin Off None Unlocked Off Open 13 Power Down
Tab le 3
To Next Page
Loading...
