806221 13
General Troubleshooting
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must
be
re
connected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
Keypad Test
Upon entry into this test, the control will display “P-”.
When a keypad is pressed the control will display “PX”
where X is the keypad number referenced in Table 4.
For keypads 10 and greater the control will display
“XX” where XX is the keypad number. As each
keypad is pressed, the nearest LED
will light up and remain lit for the duration of the
keypad test. When all keypads have been pressed the
control will automatically advance to the next step.
Keypads that are not available on some controls do not
need to be tested. Refer to Figure 1 for keypad number
and LED references.
Keypad Numbers (some models may not have all keypads)
Display Key Number LED
P1
1 22
P2
2 26
P3 3 25
P4 4 24
P5 5 Next to keypad
P6 6 Next to keypad
P7 7 Next to keypad
P8 8 Next to keypad
P9 9 Next to keypad
10 10 Next to keypad
13 11 Next to keypad
14 12 Next to keypad
15 13 Next to keypad
16 14 Next to keypad
17 15 Next to keypad
18 16 Next to keypad
19 17 Next to keypad
20 18 Next to keypad
21 19 Next to keypad
22 20 Next to keypad
23 21 23
Tab le 4
To Next Page
Loading...
