To Next PageTo Next Page
Need help?Do you have a question about the ALLIANCE BTEBXASP434AW01 and is the answer not in the manual?
Key safety terms like DANGER, WARNING, CAUTION, IMPORTANT, NOTE.
Important warnings for operating and servicing the dryer.
Guidance on finding qualified service personnel for repairs.
Contact information for parts and technical assistance.
Identifies the location of the serial plate on the dryer.
Lists the washer models covered by this manual.
Explains the dryer's operational components and airflow.
Troubleshooting flowchart for when the dryer motor doesn't run.
Troubleshooting dryer stopping during cycle or motor thermal issues.
Troubleshooting motor running but cylinder not turning.
Troubleshooting flowchart for when the dryer motor doesn't stop.
Troubleshooting dryer running only when the door is open.
Troubleshooting heating or burner ignition failure.
Troubleshooting igniter not glowing in gas dryers.
Troubleshooting burner igniting and going out repeatedly.
Troubleshooting igniter glowing but burner not igniting.
Troubleshooting heater/burner shutting off prematurely.
Troubleshooting heater/burner cycling off on limit thermostat.
Troubleshooting heater/burner not shutting off.
Troubleshooting flowchart for clothes not drying.
Troubleshooting flowchart for clothes being too hot.
Troubleshooting chattering or vibrating noise issues.
Troubleshooting humming or whistling noise issues.
List of error codes and their causes/corrections.
Troubleshooting flowchart for coins being ignored by the control.
Troubleshooting PDA communication issues with the control.
Troubleshooting flowchart for no display on the control panel.
Troubleshooting flowchart for door open detection issues.
Troubleshooting flowchart for the motor not starting.
Troubleshooting flowchart for electric dryer no heat issues.
Troubleshooting flowchart for gas dryer no heat issues.
Troubleshooting for non-electronic coin drop mechanisms.
Instructions for cleaning electronic coin drop mechanisms.
Procedure to test timer contacts and motor resistance.
Procedure to remove and disconnect the drive motor for testing.
Instructions for testing the dryer motor switch.
Procedure to test motor windings and thermal overload protector.
Steps for removing and replacing the motor switch.
Explanation of gas burner system components and operation.
Procedure to check gas valve coil resistance and voltage.
Procedure to check the gas dryer sensor resistance.
Procedure to test the igniter resistance.
Procedure to test the thermal fuse resistance.
Procedure to test the electric heater assembly resistance.
Procedure to test cycling and limit thermostats.
Procedure to test the door switch resistance.
Procedure to test the thermistor resistance.
Instructions for leveling the dryer using its legs.
Procedure for adjusting the gas burner flame.
Description of the silicon carbide ignition system.
Description of the silicon nitride ignition system.
Instructions for cleaning non-electronic coin drops.
Instructions for cleaning electronic coin drops.
Maintenance for coin drops with old-style springs.
Maintenance for coin drops with new-style springs.
General