17
Operation
Figure 11 - Troubleshooting Analysis Chart (2)
PROBLEM POSSIBLE CAUSE CORRECTION
Brake begins to
release before the
clutch is applied.
Brake is worn or needs replacement. See the Service Manual for additional
information.
Winch brake does
not apply or release
correctly.
Brake is worn. See the Service Manual for additional
information.
Control valve or control cable needs adjust-
ment.
Low oil pressure.
Clutch does not ap-
ply correctly at low
PTO rpm
Accumulator not charged. Check accumulator.
PTO speed stalled (0 rpm). Increase tractor rpm.
Worn or leaking pump. Check pump and replace if necessary.
FREESPOOL does
not operate correctly.
See the Service Manual for additional
troubleshooting, checks and adjustments.
Winch stalls tractor
engine during winch
shift when tractor
RPM is low.
Not enough engine torque. Increase engine rpm.
Low accumulator pressure. See the Service Manual for additional
troubleshooting, checks and adjustments.
Winch will not stay
in LINE-IN or LINE-
OUT (PFR only).
Handlever not adjusted. Adjust levers.
Detent gears damaged. Replace gears.
To Next Page
Loading...