28
• Step 3. The operator can move the control lever
to the LINE-IN position. If the load is less than
approximately 75% of the maximum line pull, the
operator can begin traveling with the vehicle at the
same time. The winch will wind the load toward the
vehicle as it travels. If the load is nearly the capacity
of the line pull, the operator must move the load close
to the vehicle before beginning to travel.
• Step 4. If the tractor or skidder must travel through
an area with bad traction conditions, the operator
can move the control lever to the BRAKE-OFF
position. This procedure will permit the vehicle to
move through the bad traction area without pulling
the load at the same time.
To Next Page
Loading...