Network Adapter Card Installation Guide
101
6. From the Properties window, select the Advanced tab.
Figure 61 illustrates the Advanced tab.
Figure 61. Advanced Tab of the Network Adapter Card Properties Window
7. Adjust the parameters as needed. The parameters are defined in
Table 11.
Table 11. Advanced Tab Parameters in the Network Adapter Card
Properties Window
Property Definition
Group # Assigns the adapter to a group (also
referred to as a team) for load balancing
or fail-over (LBFO) protection. A group
can have up to two adapters. This
selection appears in the window only with
the LBFO adapter card driver. For
background information, refer to “Load
Balancing and Fail-over Protection” on
page 39 and “Choosing a Network
Adapter Card Driver” on page 58.
To Next Page
Loading...
Need help?
General
