Allied Telesis AT-2400T - System Requirements; Installing AT-Stat

Network Adapter Card Installation Guide
83
System
Requirements
To run AT-Stat, your system must be operating in either Windows 2000
or XP and have an Allied Telesyn network adapter card and driver
installed.
Installing AT-Stat
To install AT-Stat, perform the following procedure:
Note
The adapter driver for an AT-2450, AT-2500, AT-2501, AT-2700, or
AT-2701 Series network adapter card must be updated to obtain
custom statistics. Otherwise, only generic statistics are available. To
update an adapter driver, refer to Updating a Network Adapter
Driver on page 57.
1. Insert the CardAssistant CD into the CD-ROM drive.
The CardAssistant Main Menu shown in Figure 59 is displayed. If this
menu is not displayed, double-click on the My Computer icon, then
double-click on the Allied Telesyn CD-ROM icon.
Figure 59 CardAssistant CD Main Menu
2. From the Driver Setup drop-down menu, select the adatper card
that you purchased.