Network Adapter Installation Guide
33
Creating a Driver Installation Disk
If the computer in which you are installing the adapter card does not
have a CD-ROM drive, you will need to create a driver installation disk to
install the adapter driver.
To create a driver installation disk, locate a computer with both a
CD-ROM and floppy drive, then perform the following procedure:
1. Make sure your computer is turned ON and the Windows operating
system is running.
2. Insert the CardAssistant CD into the CD-ROM drive.
The CardAssistant Main Menu shown in Figure 13 is displayed. If this
menu is not displayed, double-click on the My Computer icon, then
double-click on the Allied Telesyn CD-ROM icon.
Figure 13 CardAssistant CD Main Menu
3. From the Driver Setup drop-down menu, select the adapter card
that you purchased.
To Next Page
Loading...