Chapter 3: Microsoft Windows 2000, 2003, and XP
92
available only with the LBFO adapter driver. For background
information, refer to “Load Balancing and Fail-over Protection” on
page 39.
For instructions on how to set these parameters, refer to “Configuring
Additional Network Adapter Card Settings” on page 96.
Configuring the
IP Address,
Subnet Mask, and
Gateway Address
To configure the IP address, subnet mask, and gateway address or to
activate the DHCP client software, perform the following procedure:
1. From the desktop, right-click the My Network Places icon and select
Properties from the menu, as shown in Figure 51.
Figure 51. My Network Places Icon Menu
An example of the Network Connections window is shown in Figure
52.
Figure 52. Network Connections Window
To Next Page
Loading...
Need help?
General
