AT-Setup for Windows 98, 2000, Me, or XP
22
AT-Setup is located on the CardAssistant CD included with the network
adapter card or it can be downloaded from our web site at
www.alliedtelesyn.com. AT-Setup can only be used to install an adapter
driver on a system running Windows 98, 2000, Me, or XP.
To automatically install an adapter driver, refer to Running AT-Setup on
page 24. To manually install an adapter driver, refer to Manually
Installing a Network Adapter Driver on page 31.
If you are installing an adapter card in an operating system other than
Windows 98, 2000, Me, or XP, refer to the Network Adapter Card
Installation Guide - Book II. This guide is located on the CardAssistant
CD or it can be downloaded from www.alliedtelesyn.com.
Note
If you are updating an adapter driver, refer to Updating a Network
Adapter Driver on page 57.
To Next Page
Loading...