Network Adapter Card Installation Guide
73
Manually Installing a Driver
This section contains the procedure for manually installing the regular or
LBFO network adapter driver on a Microsoft Windows 2000, 2003, or XP
operating system. You can perform the procedure using the Allied Telesyn
Installation CD or, for those systems without a CD drive, a driver
installation diskette. For instructions on how to create a driver installation
diskette, refer to “Creating a Driver Installation Disk” on page 68.
1. Shutdown the Microsoft Windows 2000, 2003, or XP operating system
and power OFF your computer.
2. Install the network adapter card. Refer to Chapter 2, “Installing a
Network Adapter Card” on page 45 and the documentation that came
with your computer for instructions.
3. Power ON the computer.
After detecting the new adapter card, the system launches the Found
New Hardware Wizard, which displays the window shown in Figure 32.
Figure 32. Found New Hardware Wizard Window (1 of 4)
To Next Page
Loading...
Need help?
General
