Chapter 10: MAC Address Table
142
Static Unicast MAC Address Configuration
This procedure explains how to set the static unicast feature for each port
on the AT-FS750 switch. Before beginning this procedure, you must
create either an 802.1Q VLAN ID or a Port-Based VLAN Index. For
information about defining these parameters, see:
“Tagged VLAN Configuration” on page 182 regarding the 802.1Q
VLAN parameter.
“Port-Based VLAN Configuration” on page 190 regarding the
Port-Based VLAN parameter.
To add a static MAC address to the switch, perform the following
procedure:
1. From the main menu on the left side of the page, select the Bridge
folder.
The Bridge folder expands.
2. From the Bridge folder, select Static Unicast.
The Static Unicast Address Table Page is displayed. See Figure 43.
Figure 43. AT-FS750 Static Unicast Address Table Page
To Next Page
Loading...
