FS750 Series Fast Ethernet WebSmart User’s Guide
199
4. Use the State radio buttons to select the Private VLAN state:
Enabled - Will activate Private VLAN. The other parameters on the
web page will become active.
Disabled - Will de-activate Private VLAN. The other parameters on the
web page will become inactive and will be greyed out so that data
cannot be entered.
5. Click the Apply button at the upper right of the page.
6. To save your changes permanently, go to the main menu on the left
side of the page and select Save Settings to Flash.
The Save Settings to Flash page is displayed.
7. Click the Save Settings to Flash button.
Your changes are saved to the switch’s flash memory.
If you do not select Save Settings to Flash, your changes revert to
its original setting when you power cycle or reboot the switch.
Create a Private
VLAN
To create a private VLAN, perform the following procedure:
Private VLANs must be Enabled before a specific Private VLAN can
be created. See “Enable or Disable Private VLAN” on page 198.
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select VLAN.
The VLAN folder expands.
3. From the VLAN folder, select Private VLAN.
The Private VLAN Page is displayed. See Figure 64 on page 198 for a
partial view of this page.
4. Use the Source Port drop-down menu to select the source port.
All ports under Forwarding Ports are automatically selected, and the
source port is grayed out.
5. Select the forwarding ports:
To Next Page
Loading...
