Allied Telesis AT-FS750/28PS - Modify OUI Setting; Delete OUI Setting

Chapter 21: Voice VLAN
304
6. If you find more than one OUI among the IP phones you are installing,
enter one MAC address that represents each individual OUI by
following Step 3 through Step 5.
You can enter a total of 10 OUIs.
7. To save your changes permanently, go to the main menu on the left
side of the page and select Save Settings to Flash.
The Save Settings to Flash page is displayed.
8. Click the Save Settings to Flash button.
Your changes are saved to the switch’s flash memory.
Caution
If you do not select Save Settings to Flash, your changes revert to
its original setting when you power cycle or reboot the switch.
Modify OUI
Setting
To modify or delete an OUI, it must be first be deleted and then re-entered
by following the procedure in “Create OUI Setting” on page 303.
Delete OUI
Setting
To delete an OUI, perform the following procedure:
1. From the main menu on the left side of the page, select Voice VLAN.
The Voice VLAN folder expands.
2. From the Voice VLAN folder, select Voice VLAN OUI Settings.
The Voice VLAN OUI Settings Page is displayed. See Figure 106 on
page 303.
3. To delete a specific OUI that had already been entered in the table at
the bottom of the page, click on Delete in the Action column of the
table.
The specific OUI is deleted from the table.
4. To save your changes permanently, go to the main menu on the left
side of the page and select Save Settings to Flash.
The Save Settings to Flash page is displayed.
5. Click the Save Settings to Flash button.
Your changes are saved to the switch’s flash memory.