FS750 Series Fast Ethernet WebSmart User’s Guide
89
P2P - This parameter applies to RSTP only. Indicates if the port is
connected to another network device (point-to-point) in the network
topology.
Auto - Automatically determines whether or not the port is
connected to a network device in the network topology. By
default, Auto is enabled.
ForceTrue - The port is connected to a network device in the
network topology.
ForceFalse - The port is not connected to a network device in
the network topology.
Restricted Role - Applies only to MSTP. For information on
MSTP, refer to Chapter 5, “Multiple Spanning Tree Protocol” on
page 91.
Restricted TCN - Applies only to MSTP. For information on MSTP,
refer to Chapter 5, “Multiple Spanning Tree Protocol” on page 91.
Migrate - Clicking the Restart button under the Migrate field in the
All row restarts the protocol migration process for all ports on the
switch. Clicking the Restart button under the Migrate field for a
specific port restarts the protocol migration process for that port
only.
4. Click Apply for the port you are configuring.
5. To configure all of the ports to the same settings, in the All row,
configure any or all settings.
6. Click Apply.
7. To save your changes permanently, go to the main menu on the left
side of the page and select Save Settings to Flash.
The Save Settings to Flash page is displayed.
8. Click the Save Settings to Flash button.
Your changes are saved to the switch’s flash memory.
If you do not select Save Settings to Flash, your changes revert to
its original setting when you power cycle or reboot the switch.
To Next Page
Loading...
