Allied Telesis AT-TQ5403 Installation Guide

Chapter 2: AT-TQ5403 Access Point Installation
34
Install the Access Point
The AT-TQ5403 access point can be mounted on a table, wall, or
hard-surface celling. Before beginning the installation, be sure to
 Read “Review Safety Precautions” on page 30, and
 Review “AT-TQ5403 Access Point Installation Guidelines” on page 33.
 Select a location to install the AT-TQ5403 access point where both the
power and Ethernet cables will reach the power source and the partner
Ethernet device(s).
This section contains the following topics:
 “Table Top Installation” on page 34
 “Ceiling or Wall - Mounting Bracket Installation” on page 35
 “External AC/DC Power Adapter Installation” on page 41
 “Ceiling or Wall - Attach Chassis to Mounting Bracket” on page 43
 “Install Anti-theft Device” on page 41
Table Top
Installation
This section outlines the installation procedure to install the AT-TQ5403
Access Point on a table top.
Preparation for Table Top Installation
You need the following items to install the access point on a table top:
 AT-TQ5403 access point
 One or two Ethernet cables - See “Cable Specifications” on
page 48
 External AC/DC power supply (optional and not provided - Allied
Telesis recommends the AT-MWS0091 AC/DC Power Adapter.)
 Kensington Lock (optional and not provided)
2018-04-10_Review_Draft

Allied Telesis AT-TQ5403 Specifications

General

Brand	Allied Telesis
Model	AT-TQ5403
Category	Wireless Access Point
Language	English