AT-TQ5403 Access Point Installation Guide
43
Ceiling or Wall -
Attach Chassis to
Mounting
Bracket
Perform this procedure to complete the ceiling or wall installation by
attaching the chassis to the mounting bracket.
1. Align and insert the two access point chassis screws into the keyhole
slots of the mounting bracket. Refer to Figure 16.
Figure 16. Align/Insert Access Point into Mounting Bracket
2. Slide the chassis forward until seated into the bracket keyhole slot and
the bracket thumbscrew is aligned with the screw hole on the front of
the chassis, as shown in Figure 17.
Figure 17. Seat Access Point onto Mounting Bracket
To Next Page
Loading...
