Allied 595 - Page 19

Removing the Loader from Your Tractor
(Continued)
4.
Roll back the bucket slightly and simultaneously extend or retract
the lift cylinders to free hooks from spools. Then slowly back
up the tractor.
5. Once the subframe is clear of the boot and the hook is clear of the mounting boss, roll
back the bucket aii the way. This raises the rear uprights of the ioader.
NOTE: On some mountings, the lift cylinders
must be extended more while the tractor is
backing up, so that the subframes clear the
front axle.
CAUTION! Be sure the hoses DO NOT get
pinched or catch on any frame members
while backing up._
7. After the loader is clear, retract the lift cylinders to protect the shafts and disconnect the
hydraulic lines at quick couplers.
17