REAR WHEEL & AXLE HOUSING
' .. :"; .
. ;..
Removal
Drain transmission to pre_ve!1!C)ilfrom con-
tacting brake bands. Remove the-rear-whee!
to prevent damage to oil seals. When removing
the left hand axle housing, the clutch pedal rod
must be removed. Remove the bolt from the
gas tank support and the four nuts attaching
housing to transmission and differential case.
938-1 CROSSBARwith 31/4" CENTERS
930J LEG ENDS
REMOVINGBRAKE DRUM
Remove the two bearing clamp ring retaining
screws from the outer end of axle and attach
the OTC puller as shown and pull brake drum
from shaft. To remove the cast drum use OTe
20M adaptor (5/8" male NC and 5/8" female
NF) in place of the 930J leg ends. To replace
oil seal or bearing, pull the bearing clamp ring
from the axle shaft.
Inspection
Always use a new oil seal. Check the brake
-drum for scoring.
Assembly
Place the oil seal on the axle with the lip towards
the bearing. Place bearing cn the axle with the
shielded side away from the seal. Pack the
bearing with chassis lubricant. Install the bear-
ing clamp ring with the small end towards the
bearing. Always use a new clamp ring. The
axle is retained by the press fit of the clamp
rin •
INSTALLING BRAKE DRUM
Install the axle in the housing. Tighten the bear-
ing retaining screws to 10 ft. lbs. Lock with
lacing wire.
Install the brake drum using a piece of 1-1/4"
tubing 8" long and a heavy bar of iron in the
OTC puller as shown.
PULUNG BEARINGCLAMP RING
G-28
To Next Page
Loading...
