4
SR OPERATORS MANUAL
Safety Notes:
When working on electric vehicles, sudden unexpected events can
occur, it’s recommended to:
• Place the drive axle on jack stands—wheels off the
oor.
• When working on wiring or batteries, always remove
rings and watches.
• Use the proper safety equipment, eye protection, and
insulated tools.
• Never connect a computer while the vehicle is being
charged.
• Disconnect batteries before installing or working on
the controller.
• Wear safety glasses.
• Because hydrogen can build up due to gassing from
the batteries, work in a well ventilated area.
• Make sure the battery pack is fused.
• Do not clean the controller with a high PSI pressure
washer.
•When cleaning batteries, take precautions to keep the
battery acid from splashing on the controller.
Note:
It is the installer’s responsibility to ensure the correct equipment
(ie. wire, motor, solenoid, fuse etc) is installed in the car.
READ AND SAVE THESE
INSTRUCTIONS
WARNINGS
To Next Page
Loading...
Need help?
General
