FMI-B
FMI-S
Bedienungsanleitung
Operation manual
Notice d’utilisation
Instrucciones de servcio
Istruzioni per l’uso
www.alluris.de
Page 18 of 34
4.2.5. Automatic measuring stop
– Auto-Stop for FMI-B
(P14)
Force gauges series FMI-B come as well as series FMI-S with an auto-
stop function. Measurings are stopped automatically when measured
values are stable over a defined period of time. The auto-stop function
applies if the device is not connected to an external power supply. By
default instruments series FMI-B are set to O = no auto-stop. Subme-
nu 14 allows to adjust this function by pressing the I-key.
[Auto-Stop after: 0 - 10 - 20 - 30 seconds]
By pressing the S-key for 2 seconds you return to the operation level.
4.2.6. Auto-Off function (instrument off) (P15)
Force gauges running without USB cable are turned off, if no button is
pressed for more than five minutes - as long as you are not working in
the settings menus. Submenu 15 allows to adjust this period of time
by pressing the I-key.
[Auto-Off after: 1 - 2 - 3 - 5 - 10 - 30 - 60 - 90 minutes]
By pressing the S-key for 2 seconds you return to the operation level.
4.2.7. Automatic taring function – Auto-Tara (P16)
Instruments are taring automatically when starting a measurement.
Thus the influence of the installed attachments according to the posi-
tion of the instrument and temperature variations between measure-
ments are eliminated.
To continue with a pausing measurement it can be neccessary to
deactivate this function. Submenu 16 allows to deactivate this func-
tion with the I-key.
[Auto-Tara: 1
= On - 0 = Off]
By pressing the S-key for 2 seconds you return to the operation level.
To Next Page
Loading...
Need help?
General
