Need help?Do you have a question about the Allweiler AE Series and is the answer not in the manual?
Instructions for installing angular-contact and groove ball bearings.
Procedure for correct installation of the mechanical seal unit.
Instructions for mounting the driving shaft and its shaft seal.
Guidance on correct mounting of the rotor and its side joint.
Steps for installing the joint shaft and drive-side joint.
Detailed instructions for proper mounting of the pump stator.
General| Type | Centrifugal Pump |
|---|---|
| Series | AE |
| Material | Cast iron, bronze, stainless steel |
| Pressure Rating | Up to 16 bar |
| Connection Types | Flanged |
| Speed | 1450 rpm, 2900 rpm |
| Seal Type | Mechanical seal |
To Next Page