Allworx Connect 536 - Connect Network Ports

Allworx
®
Connect™ Server Family Installation Guide
866.ALLWORX * +1 585 421 3850 Page 19
www.allworx.com
Version: F Revised: June 21, 2018
4.4 Connect the Network Ports
The data network ports are 10/100/1000 BASE-TX auto-sensing and auto MDI-MDIX ports. The
network port availability on the Connect servers is:
After properly configuring the server (see the Allworx System Administrator’s Guide
Install Checklist, for
more information), plug in the network infrastructure cables. Use standard RJ-45 category 5e network
cables or better.
Caution:
Do not plug any network or ISP service into the Connect server without first properly configuring
the server as this may result in a disruption of network connectivity with other equipment on the
network.
MISE EN GARDE :
Ne branchez pas un réseau ou un service d’accès Internet (ISP) au serveur Connect, sans avoir
d’abord correctement configuré le serveur, car cela pourrait entraîner une interruption de la
connectivité réseau à d'autres appareils du réseau.
PRECAUCIÓN:
No conecte ningún servicio de red o ISP al servidor Connect sin haber configurado primero el
servidor, ya que esto puede ocasionar interrupciones en la conectividad de la red con otros
equipos dentro de la red.
Connect server
Port 300 Series 500 Series 731
ETH0
XXX
ETH1
XXX
ETH2
XX
LED Identification LED State Description
Green
Off No Link: no network connection.
On Link: successful network connection.
Blinking Activity: transmitting or receiving data.
Amber
Off Speed: 10 or 100 Mb/s
On Speed: 1000 Mb/S