5
Chapter 3
Operation
Keypad Functions
Press to turn the Alnor AVM430/Airflow
Instruments TA430 on and off. During the power
up sequence the display will show the following:
Model Number, Serial Number, Software
Revision and Last Date Calibrated.
Press to scroll through choices while setting a
parameter.
Press to accept a value or condition.
Arrow ( or ) and
Menu Soft Keys
Press arrow keys to change choices while
setting a parameter. Press the Menu soft key to
select the Menu selections, which are Display
Setup, Settings, Flow Setup, Actual/Std Set up,
Data Logging, and Calibration.
Common Terms
In this manual there are several terms that are used in different
places. The following is a brief explanation of the meanings of those
terms.
Consists of all of the measurement parameters stored at
the same time.
A group of samples. The statistics (average, minimum,
maximum, and count) are calculated for each test ID.
The maximum number of test IDs is 100.
The time constant is an averaging period. It is used to
dampen the display. If you are experiencing fluctuating
flows, a longer time constant will slow down those
fluctuations. The display will update every second, but the
displayed reading will be the average over the last time
constant period. For example, if the time constant is 10
seconds, the display will update every second, but the
displayed reading will be the average from the last 10
seconds. This is also referred to as a “moving average”.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
Need help?
General
