Place clamp on the swivel
bases.
MOUNTING THE FRAME
Loosen and remove the
fine adjustment knobs, flip
the head/throat frame
supports so that they
(supports) are each in an
upward position. Replace
the fine adjustment knobs.
To accommodate the
length of each racquet,
adjust the mounting arm
post by loosening the
mounting post adjustment
knob. Once the correct
length adjustment is reached, tighten the mounting
post adjustment knob. CAUTION: Make sure that
both mounting post adjustment knobs are tightened
and secured. Not doing this will allow the mounting
arms to creep forward during the stringing process
and cause damage to the racquet. NOTE: Both
mounting arms are identical, the racquet can be
mounted either way.
To Next Page
Loading...
